KDS FLYMENTOR DRIVER DOWNLOAD

Check the servo arm center at half stick at this point. Did you follow the intructions and set the servos to move in the correct way when you tipped the heli under the servo tab before you set up stick directions under the control tab. Oct 20, , Lastly, I have done a lot of tail tuning and now have the tail gyro operating reasonably well, however, it does tend to drift still. It eats up vibes and sticks like glue.

Uploader: Kajizragore
Date Added: 24 October 2008
File Size: 22.8 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 83135
Price: Free* [*Free Regsitration Required]

If you are using the FM tail gyro Gray wire connects to the rudder port, Green connects to the gyro gain port.

FlyMentor Setup By Ivor Hill PLEASE READ FIRST!! – HeliFreak

You may need to use a little TX trim for best performance. Because the blue wire is disconnected, The FM gain it controlled by Helibal. Oct 17, Gear switch used for mode switching but also tlymentor to itself for activation though the flight mode 3 position switch. If you are using a separate tail gyro leave it connected as it is to the Rx, and leave the gray and green wires disconnected.

Show Attachments in this Thread. Using this there is no need for the velcro strap.

The next step is to re-level and center the swash. Originally Posted by Livonia bob Yes I have tried to just turn the camera around Would you like to come and tidy up all my heli’s LOL.

Recent Drivers  SAMSUNG SPH-M900 DRIVER

If you use your existing gyro the Flymentor gyro still has to be fitted because it also contains the stabilization gyro,so you would have 2 gyro’s kes to your heli. Originally Posted by merc hmmmm If it found that the images is not same as the previous image, it will adjust the servo and auto correct it for you! I will report this back to the supplier also.

Connect servo wires to flymentor unit show in the picture below. Quote message in reply?

Return to Electric Heli Talk. Read though this first before asking hardware setup questions. This review divided into installation and testing.

My experiences and setup of KDS Flymentor – RC Groups

Expert understands the inner workings General knows how to use it Novice still getting used to it. You may need to use a little TX trim for best performance.

Connect power to ESC and wait for helibal to load the configuration from the main unit. You can also use setup card for trimming? Switch to Threaded Mode. In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Recent Drivers  DRIVERS FOR ATTO FC42ES

KDS FlyMentor 3D RC Helicopter Auto Stabilizer with GYRO

After that select servo reverse option and neutral. Just swap both wires at the receiver. In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Just like setting the gain on a tail gyro. Originally Posted by merc Hi Mike, yes I have had some “fun” with the thing!! Connections of gear and aux is optional. Remember Me Forgot Password?

By using the Flymentor, it will automatically correct the cyclic servos and keeps the helicopter always in horizontal mode. However when I’m testing the servo throws before flying, the swash sometimes flymentof erratically. Is there an advantage to using a separate gyro rather than using the FM for all axes stabilization? If you are using flymeentor separate tail gyro leave it connected as it is to the Rx, and leave the gray and green wires disconnected.